![]() ![]() Just connect the BUS+ and GND wires from the circuit to the appropriate pins on the microphone connector as shown in the programming cable schematic. If you want to build a nice little programmer for the GM300/M120 radios, one that does not require a RIB, check out this link. you can follow this procedure to do the conversion. ![]() If you happen to mess up the codeplug in your radio, and for some reason consider it necessary to make it into a Maxtrac. You may find that the radio already has user-selectable scan, enabled off the front panel. mdf file, and the RSS just crashes when you try to load a codeplug. Good luck in adding scan to a GM300 8 Channel radio, tried it by editing the. But how, you ask, since it only has a 2 digit display? It encodes (in HEX) the first two numbers of the PTT ID. ![]() This radio can decode and display up to 126 PTT IDs. Here is the pinout of the microphone connector.Īre you having problems getting your radio to power up? Well, check here for some information that might help. One thing to note, the HLN9242A kit also includes a pin extractor for removing previously installed pins. These include an accessory connector housing, some pins, and some wires with pins already attached. If you want an easy way to connect to the Accessory Connector on these radios, you can order the HLN9242A or HLN9457A Accessory Connector kits. Look here for the pinout of the accessory connector for the 8 channel radio (which use a masked logic board) or 16 channel radio (which use an expanded logic board). The M120 is just the limited version, not unlike the Maxtrac 50 compared with the Maxtrac 300. The GM300 and the M120 are the same series of radio. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |